7
fi-6010N Network Scanner Operator's Guide 423
Chapter 7
Scanner Care
This chapter describes how to clean the scanner and replace parts in order to maintain the scanner
in optimum scanning condition.
The glass scanner windows inside the ADF can become hot when the
scanner is used.
Before cleaning inside the scanner or replacing any parts, turn off the
power, unplug the AC adapter from the outlet, and wait for at least 15
minutes.
The power does not need to be turned off when cleaning the feed rollers.
Do not use any aerosol sprays or alcohol based sprays to clean the
scanner.
Dust blown up by strong air from the spray may enter the inside of the
scanner. This may cause the scanner to fail or malfunction.
Sparks, caused by static electricity, generated when blowing off dust and
dirt from the outside of the scanner may cause a fire.
7.1 Cleaning............................................................................................................... 424
7.2 Cleaning the ADF ................................................................................................ 426
7.3 Cleaning the LCD Touch Panel.......................................................................... 433
7.4 Cleaning the Keyboard....................................................................................... 434
7.5 Cleaning the Carrier Sheet................................................................................. 435
7.6 Replacing Parts................................................................................................... 436
7.7 Performing a Scan Test...................................................................................... 445
To Next Page
Loading...
