132
4.7.14 Setting the Network Folders
A list of network folders may be set as "Save" targets for scanned data.
Any accessible file server folder or FTP server folder may be specified.
Up to 100 network folders and FTP server folders can be added.
A network folder can be added in either of the following ways.
z Network Tree
Select a network folder from the network tree.
For details, refer to "Registering a Network Folder (Network Tree)" (page 133).
z Network Path
Set a network folder by directly entering the path alias for the file server folder.
For details, refer to "Registering a Network Folder (Network Path)" (page 136).
z FTP Path
Set a network folder by directly entering the path alias for the FTP server folder.
For details, refer to "Registering a Network Folder (FTP Path)" (page 138).
Note the following when registering a network folder.
z The network folder is registered as a network path. If the network folder is
on a Windows file server and the length of the full Windows path including
the file name exceeds 259 characters, the scan data will not be saved.
Before registering a (Windows) network folder, check that the length of the
full file path+name is not likely to exceed 259 characters.
z If the selected folder was created using a language foreign to that of the
browsing operating system, the network folder may not register correctly. If
the name of the network folder contains unrecognizable characters, check
the codeset used.
z If the number folders to be displayed is large, they may take a long time to
appear.
To Next Page
Loading...
Need help?
General