GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-63
3-7-6-2 Disconnecting the Ultrasound Unit from the Electrical Outlet
1) Power down the unit.
2) Unplug the mains power cable connector from the AC input socket on the SafeLock Cart or the
AC-DC converter of the system.
3) Unplug the mains power cable from the AC wall outlet socket.
4.) Unplug the AC/DC power connector from the Vivid i n/ Vivid q N rear panel.
CAUTION
Make sure the system is powered OFF or in standby mode before disconnecting the Vivid i n/
Vivid q Nunit from the electrical outlet and proceed as described in the steps below.
To Next Page
Loading...
