GE Vivid i n - Formatting and Partitioning the Hard Disk

To Next Page

To Previous Page

GE HEALTHCARE

DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL

Chapter 8 - Replacement Procedures 8-121

8-5-4 Formatting and Partitioning the Hard Disk - Automatic Procedure

If partition C:\ has been stored by using the Rollback tool described in the Software Roll-back

Procedure (see page 8-139), it will be DELETED after performing the following procedure.

1) Connect the DVD\CD-RW drive to the system’s USB and connect the power supply of the drive to

power outlet.

2) Place the GHOST CD inside the DVD\CD-RW Tray and close tray.

3) Turn ON power to the system and allow it to boot up from the CD.

A menu will appear prompting for selection of one of four options:

4) Select option: 1: Vivid_i Full Clean Install (System + Application Software)

A menu will appear prompting for selection of the required option:

5) Select “B” service tools.

6) Type in the password “geulsservice” and press <Enter>.

A menu will appear prompting for selection of one of seven options:

GE Vivid i n - Formatting and Partitioning the Hard Disk - Automatic Procedure