GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
8-108 Section 8-5 - Software Loading
8-5-2 Setting the BIOS
NOTE: This procedure is applicable to both MODBR949 and MODBR929 versions.
1) While booting, press F2 “Config / Diag” on alphanumeric keyboard
2) Type the password “marlin04”.
3) Exit and save presets.
4) Select <Exit> section and load “Setup Defaults”.
5) Select <Main> section.
6) Set correct System Time and System Date. Set Date using next format MM/DD/YYYY
7) Check that IDE Primary Master is detected.
8.) Proceed to Setting the BIOS Advanced Parameters on page 8 - 109.
Figure 8-108 BIOS Main Tab
To Next Page
Loading...
