GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
8-86 Section 8-4 - SafeLock Cart Components Replacement
8-4-14 LAN Isolation Box and Holder Replacement Procedure
8-4-14-1 Tools
Appropriate Phillips screw driver.
8-4-14-2 LAN Isolation Box and Holder Removal Procedure
1) Disconnect the LAN communication cable.
2) From below the Top Shelf, remove the two LAN Holder retaining screws (see Figure 8-99) and
remove the LAN Holder.
3) Remove the LAN Isolation Box.
8-4-14-3 LAN Isolation Box and Holder Installation Procedure
1) Position the LAN Isolation Box in the LAN Holder and replace the LAN Holder with the Isolation Box
in their appropriate location beneath the Top Shelf.
2) Return and tighten the two retaining screws to secure the LAN Holder.
3) Connect the LAN communication cable.
Figure 8-99 LAN Holder and Isolation Box
Retaining Screws located behind
LAN Holder
LAN Isolation Box
LAN Communication Cable
LAN Holder
To Next Page
Loading...
