GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-27
8-2-8 LCD Display Frame Replacement Procedure
8-2-8-1 Tools
Use the appropriate Phillips and flat screw drivers, as indicated in the bottom assembly replacement
procedures.
8-2-8-2 Time Required
10 minutes
8-2-8-3 Preparations
Shut down the Vivid i n/ Vivid q N ultrasound unit, as described in - System Setup.
8-2-8-4 LCD Display Frame Removal Procedure
1) With the LCD Display in the open (upright) position, use a flat screwdriver to remove the screw cap
from each of the four screws that fasten the LCD display frame in position, as shown in Figure 8-30
below.
Figure 8-30 Removing the Screw Caps from the LCD Display Frame
2) Loosen and remove the four screws (Figure 8-31).
3) With the LCD Display in the fully open position, carefully release the LCD display frame from the
Figure 8-31 Removing the Securing Screws
To Next Page
Loading...
