GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-19
Section 7-3
Performing Full System Diagnostics
When performing the automatic Full System Diagnostic tests, it is strongly recommended to start with
the Full System Test (FE and BEP) - especially if the Vivid i n/ Vivid q N system shows signs of an
intermittent problem. As described in this section, the testing sequence can be paused and restarted at
any stage, providing a quick and easy method of reviewing any detected faults.
The different types of Full System Diagnostic Tests are described in detail in the Diagnostic Test
Window Menu Options section, on page 7-10. For instructions on performing each of these tests, refer
to the following information:
• Full System Test (FE and BEP) on page 7 - 20
To Next Page
Loading...
