GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-135
8-5-9 Installation of PMC Version
1.) Allow the system to boot up into Normal Scanning mode.
2) Press Config.
The system will prompt you to login.
3) Login as ADM.
The default password is ulsadm
4) Press the About button and activate the FwVersion tab; verify that PMC version is 19 or above, as
shown in the example in Figure 8-131 below.
5) Turn the system OFF and remove the DVD USB cable and both battery and AC adapters.
6) Connect the AC adapter only (NO BATTERY).
7) Boot up the system in Maintenance mode, using the Service Dongle.
8) Go to the following directory: My Computer C:\marlin\Target\bin.
Figure 8-131 Verifying PMC Version
To Next Page
Loading...
