GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
3-178 Section 3-12 - Completing the Installation Paperwork
Section 3-12
Completing the Installation Paperwork
NOTE: On completion of a Vivid i n/ Vivid q N ultrasound scanner installation, it is important to record the
relevant System Installation details (see Table 3-12 below) and Product Locator Installation details (see
Figure 3-190 on page 3-179), for future reference.
3-12-1 System Installation Details
Enter the serial number printed on the main label (refer to the Product Labels and Icons section, on
page 1-12), and the other relevant system installation details into the following table:
3-12-2 Product Locator Installation
NOTE: During and after installation, the documentation (i.e. User Manuals, Installation Manuals...) for
the peripheral units must be kept as part of the original system documentation. This will ensure
that all relevant safety and user information is available during the operation and service of the
complete system.
1.) Verify that all details have been entered in the System Installation Details form, as described in the
System Installation Details section, above. If this form has not been completed, enter the details
now.
2.) Locate the Product Locator Installation Card(s) that are affixed to the monitor and to each of the
peripherals, and fill in all details on both the front and back of the card(s) - see Figure 3-190
"Product Locator Installation Card (Example)" on page 3-179.
NOTE: Step 2 may have been completed already by GE personnel.
The Product Locator Installation Card shown in Figure 3-190 "Product Locator Installation Card
(Example)" on page 3-179 may not be identical to the card(s) provided.
3.) Mail the Product Locator Installation Card(s) to the appropriate product center.
Table 3-12 System Installation Details
System S/N:
Location:
Date:
Customer Name:
Service Engineer’s Name:
Comments:
To Next Page
Loading...
