GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
8-122 Section 8-5 - Software Loading
7) Select “A” (for BT06 systems) or “B” (for BT09 systems) to format and re-partition the
complete hard disk.
Note: The system will partition the hard disk as follows:
C: = 5GB
D: = 5GB
F: = 1GB
E: = Remaining space (i.e. complete hard-disk size minus 11GB for partitions C, D, and F).
IMPORTANT: Do not stop the operation during this process!
8) When complete, continue with the software installation procedure. Refer to the relevant section.
Note: In the event that the above process fails, one can perform the hard-disk partitioning
procedure manually, as described below.
9.) Proceed to perform the following functionality tests:
- Software Configuration Checks on page 4 - 37
- Calibration Tests on page 7 - 25
- Full System Test on page 7 - 10
To Next Page
Loading...
