GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
3-80 Section 3-9 - Configuration
3-9-3-6 Add Printer
NOTE: This option should not be used by un-authorized personnel. This option will prompt you to the
Windows Installation Wizard. Normally, all software drivers are pre-installed and there is no
need to use this functionality. In special cases where there is a need, follow the instructions
provided by GE Medical Systems or the instructions in the respective printer installation
manual.
1.) Select ADD PRINTER
to start the Add Printer (Installation) Wizard.
2.) Follow the instructions in the Wizard to install a new printer.
3.) When done, perform a full system shutdown, then boot-up the system into Normal Scannng mode.
Restarting the system allows the changes to take effect.
The newly-added printer is now listed and available for selection.
Figure 3-78 Select Add Printer
Figure 3-79 Add Printer Wizard
Select Add Printer
To Next Page
Loading...
