GE Vivid i n - Page 270

GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
4-22 Section 4-3 - Functional Checks
4-3-1-4 Trackball Test
4-3-1-5 System ID Test
Table 4-8 Trackball Test - Recommended
Step Task Expected Result(s)
1
Boot-up the System in Regular Scanning Mode
2
Press Config
3
Under the Connectivity tab, select TCPIP then
Advanced Settings
4
Click on View
5
In the address bar, type Desktop and press <Enter>
6
Select My Docs > My Pictures and double-click on one
of the pictures to open the Paint application.
7
From the Paint window, make sure that when moving the
trackball you have good control and that the x and y
coordinate values (displayed at the bottom of the
screen) move digit-by-digit up and down.
Movement is smooth (no jumping) and the trackball has
no “dead” areas (i.e., when the trackball is moved there
are no areas in which no changes are seen).
Table 4-9 System ID Test - Recommended
Step Task Expected Result(s)
1
Boot-up the System in Regular Scanning Mode
2
Press Config
3
Under the Connectivity tab, select TCPIP then
Computer Name
4
Make sure the computer name is System ID
5
Select Advanced Settings
6
Type Desktop and press <Enter>
7
Select My Computer and press Menu
8
From the drop-down menu, select Properties and then
select the Computer Name tab.
9
Make sure the System ID is indicated under the
computer description.
The computer description matches the system ID.