GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-133
When done, the Installation Complete message is displayed:
10) Move the cursor over the displayed message window and press the SET button.
11.)Press any key to re-boot the system.
The system re-boots into Normal Scanning mode.
12.)Press Config and then About.
The newly-installed software version is now listed under the System Version tab:
13.)Remove the DVD from the DVD\CD-RW drive and close the tray.
14.)Proceed to perform the following functionality tests:
- Software Configuration Checks on page 4 - 37
Figure 8-129 Software Installation Complete Message
Figure 8-130 Software Version
To Next Page
Loading...
