UCM6200 Series User Manual
Fill in the Email address for the user. Voicemail will be sent to this Email address.
Configure the password for user portal access. A random numeric password is
automatically generated. It is recommended to use the randomly generated password
for security purpose.
Select the voice prompt language to be used for this extension. The default setting is
"Default" which is the selected voice prompt language under Web GUIPBX
SettingsVoice PromptLanguage Settings. The dropdown list shows all the
current available voice prompt languages on the UCM6200. To add more languages
in the list, please download voice prompt package by selecting "Check Prompt List"
under Web GUIPBX SettingsVoice PromptLanguage Settings.
The maximum endpoints which can be registered into this extension. For security
concerns, the default value is 1.
Configure the phone number for the extension, user can type the related star code for
phone number followed by the extension number to call directly this number.
Example: user can type *881000 to call the mobile number associated with extension
1000.
Table 32: SIP Extension Configuration ParametersMedia
Use NAT when the UCM6200 is on a public IP communicating with devices hidden
behind NAT (e.g., broadband router). If there is one-way audio issue, usually it's
related to NAT configuration or Firewall's support of SIP and RTP ports. The default
setting is enabled.
By default, the UCM6200 will route the media steams from SIP endpoints through
itself. If enabled, the PBX will attempt to negotiate with the endpoints to route the
media stream directly. It is not always possible for the UCM6200 to negotiate
endpoint-to-endpoint media routing. The default setting is "No".
Select DTMF mode for the user to send DTMF. The default setting is "RFC2833". If
"Info" is selected, SIP INFO message will be used. If "Inband" is selected, 64-kbit
PCMU and PCMA are required. When "Auto" is selected, RFC2833 will be used if
offered, otherwise "Inband" will be used.
If the phone has an assigned PSTN telephone number, this field should be set to
“User=Phone”. “User=Phone” parameter will be attached to the Request-Line and
“TO” header in the SIP request to indicate the E.164 number. If set to “Enable”, “Tel”
will be used instead of “SIP” in the SIP request.
When present in an INVITE request, the alert-Info header field specifies and
alternative ring tone to the UAS.
Enable or disable T.38 UDPTL support.
To Next Page
Loading...
Need help?
General
