UCM6200 Series User Manual
Enable SRTP for the call. The default setting is "No".
Select Fax Mode for this user. The default setting is “None”.
• None: Disable Fax.
• Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this extension.
If no Email address can be found for the user, the Fax will be sent to the default
Email address configured in Fax setting page under Web GUICall
FeaturesFax/T.38.
This option controls how the extension can be used on devices within different types
of network.
• Allow All
Device in any network can register this extension.
• Local Subnet Only
Only the user in specific subnet can register this extension. Up to three subnet
addresses can be specified.
• A Specific IP Address
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
If enable “All”, users do not need to enter password when making an outbound call.
If enable “Follow Me”, the call can dial out via follow me without password.
Select audio and video codec for the extension. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, iLBC, ADPCM, LPC10, H.264,
H.263, H.263p and VP8.
Search and Edit Extension
All the UCM6200 extensions are listed under Web GUIExtension/TrunkExtensions, with status, Extension,
CallerID Name, Technology (SIP, IAX and FXS), IP and Port. Each extension has a checkbox for users to "Modify
Selected Extensions" or "Delete Selected Extensions". Also, options "Edit” , "Reboot" and "Delete"
are available per extension. User can search an extension by specifying the extension number to find an
extension quickly.
To Next Page
Loading...
Need help?
General
