UCM6200 Series User Manual
Select the default destination for the inbound call.
• Extension
• Voicemail
• Conference Room
• Queue
• Ring Group
• Paging/Intercom
• Voicemail Group
• Fax
• DISA
• IVR
• Dial by Name
• External Number
• By DID
When "By DID" is used, the UCM6200 will look for the destination based on
the number dialed, which could be local extensions, conference, call queue,
ring group, paging/intercom group, IVR, voicemail groups and Fax extension
as configured in "DID destination". If the dialed number matches the DID
pattern, the call will be allowed to go through.
Configure the number of digits to be stripped from the beginning of the DID. This
option shows up only when "By DID" is selected.
Configure the number of digits to be prepended to an inbound DID pattern, with
strip taking precedence over prepend.
This option shows up only when "By DID" is selected. If enabled, the external users
dialing in to the trunk via this inbound route can dial outbound call using the
UCM6200’s trunk.
This option shows up only when "By DID" is selected. This controls the destination
that can be reached by the external caller via the inbound route. The DID
destination are:
• Extension
• Conference
• Call Queue
• Ring Group
• Paging/Intercom Groups
• IVR
• Voicemail Groups
• Fax Extension
• Dial by Name
• All
To Next Page
Loading...
Need help?
General
