Hioki 3196 - Checking the Connection; Confirming the Connection Diagram

4.2 Checking the Connection
45
4.2.1 Confirming the Connection Diagram
4.2 Checking the Connection
WIRING
WIRING
Example: 3P4W (three-phase four-wire)
❖ Setting the connection method (page 45)
❖ Setting the nominal voltage (page 46)
❖ Setting the measured frequency (page
46)
Setting the connection method
WIRING
Wiring
Select from pull-
down menu
Confirm
Cancel
1P2W To measure single-phase two-wire power lines
1P3W To measure single-phase three-wire power lines
3P3W2M To measure single-phase three-wire power lines
(using the 2 power meter method)
(Use this when measuring three-phase power with 2-
spot current measurement only.)
3P3W3M
To measure three-phase three-wire power lines
(using the 3 power meter method)
3P4W To measure three-phase four-wire power lines