Hioki 8730-10 - Page 53

37
_____________________________________________________________________________________________
3.2 Basic Measurement and Setting
______________________________________________________________________________________________
EXTEND
0.50 DIV (500 mV)
0.50 DIV (500 mV)
0.50 DIV (100 μs)
0.50 DIV (100 μs)
5. Load the waveform data and create an area.
Press the
START
key to load the
waveform data.
Press the
AREA EDIT
key and execute
the "
LOAD
" command.
Set the load source to "
CH1
" and the
mode to "
LastWave
."
6. Extend the comparison area.
Use the "
EXTEND
" command to set
the width, then press the
START
key.
7. Save the created area to internal memory.
Select the "
SAVE
" command to save
the area created.
In this example, the area will be saved
in "
A07
."