38
_____________________________________________________________________________________________
3.2 Basic Measurement and Setting
______________________________________________________________________________________________
Comp
CommonStopMode Area or Value
Refresh Disp Always
Select Mode (Do not set)
Register Mode (Do not set)
Re-compare (Disabled by default.)
Area
Comparison ON
CH1 - FAIL Mode OUT
CH1 - Using Area A07
Stop Mode FAIL
8. Exit the Editor screen
Select "
EXIT
" and press the
ENTER
key.
9. Set the comparison parameters.
Press the
COMP SETTINGS
key.
10. Set the area comparison parameters.
Select the "
Area
" tag and set the
parameters as shown below.
In this example, the "
Value
" tag setting is
not made.
To Next Page
Loading...
