Hioki ST5540 - Page 165

8.6 Message Reference
159
8
Chapter 8 Controlling the Instrument From a Computer
Protective conductor ammeter mode
Event register
HeaderEvent register
System
Messages Explanation Ref page
:CONFigure:PCC
Sets the measurement current
(protective conductor ammeter)
(p. 195)
:CONFigure
:PCC?
Queries the measurement current
(protective conductor ammeter)
(p. 195)
:CONFig-
ure:PCC:RANGe
Sets current range (protective conductor ammeter)
(p. 195)
:CONFig-
ure:PCC:RANGe?
Queries current range (protective conductor ammeter) (p. 195)
Messages Explanation Ref page
:ESR0?
Queries the event status register 0 (p. 208)
Messages Explanation Ref page
:HEADer
Sets the response header (p. 208)
:HEADer?
Queries the response header (p. 208)
Messages Explanation Ref page
:SYSTem:BACKlight
Sets the backlight automatic OFF function (p. 225)
:SYSTem:BACKlight?
Queries the backlight automatic OFF function (p. 225)
:SYSTem:BEEPer
:COMParator
Queries the beep sound
(Judgement of allowable value)
(p. 225)
:SYSTem:BEEPer
:COMParator?
Queries the beep sound
(Judgement of allowable value)
(p. 225)
:SYSTem:BEEPer:KEY
Sets the beep sound (Key entry) (p. 226)
:SYSTem:BEEPer:KEY?
Queries the beep sound (Key entry) (p. 226)
:SYSTem:BEEPer:T2OUt
Sets the beep sound (T2 output) (p. 226)
:SYSTem:BEEPer:T2OUt?
Sets the beep sound (T2 output) (p. 226)
:SYSTem:BEEPer:T3OUt
Sets the beep sound (T3 output) (p. 227)
:SYSTem:BEEPer:T3OUt?
Queries the beep sound (T3 output) (p. 227)
:SYSTem:CLEar
Clears the panel (p. 227)