Hioki ST5540 - Page 164

8.6 Message Reference
158
Measurement data
Saved data
Voltmeter mode
:STOP
Stops automatic measurement (p. 224)
Messages Explanation Ref page
:MEASure?
Queries the measurement value (p. 210)
:MEASure:AUTO?
Queries the maximum value after automatic
measurement
(p. 211)
:MEASure:MAXimum?
Queries the maximum value (p. 213)
:MEASure:VOLTage?
Queries the voltage measurement value (p. 214)
:MEASure:PCC?
Queries the protective conductor current value (p. 214)
Messages Explanation Ref page
Messages Explanation Ref page
:MEMory:CLEar
Deletes the saved data (p. 215)
:MEMory:NUMBer?
Queries the number of models in the saved data (p. 215)
:MEMory:READ
:IDENtity?
Queries the equipment name/control number of the saved
data
(p. 215)
:MEMory:READ
:MEASure?
Reads saved data (p. 217)
:MEMory:SAVE:AUTO
Saves automatic measurement results (p. 219)
:MEMory:SAVE
:MAXimum
Saves the maximum value (p. 220)
Messages Explanation Ref page
:CONFigure:VOLTage
Sets the target voltage (p. 202)
:CONFigure:VOLTage?
Queries the target voltage (p. 202)
:CONFigure
:VOLTage:RANGe
Sets the voltage range (p. 203)
:CONFigure
:VOLTage:RANGe?
Queries the voltage range (p. 203)