MAINTENANCE AND ADJUSTMENT OF THE UTV
- 94-
5. If the oil filter cartridge is also to be replaced,
perform the following procedure.
·Remove the oil filter cartridge ① with an oil
filter wrench .②
·Lubricate the O-ring of the new oil filter③
cartridge with a thin coat of
lithium-soap-based grease.
NOTE:
Make sure that the O-ring ③ is positioned
correctly in the groove of the oil filter
cartridge.
· Tighten the new oil filter cartridge to
specification with an oil filter wrench.
6. Install：
·engine oil drain bolt ①
7. conditions
·Change for new oil filter before impouring oil
to crankcase, and make sure it is in good
working condition before assembling.
·make sure that the oil reach regular level
when the vehicle is placed on flat ground.
Oil level of gearbox
Periodic oil change
The oil capacity after the engine is
disassembled and reassembled.
1.9L
The oil should be put into the engine for
after all the oil is drawn out
1.8L
8. Install:
·engine oil filler plug
9. Warm up the engine for a few minutes, then
stop the engine.
10. Check:
·engine (for engine oil leaks)
Oil filter cartridge
17 Nm (1.7 m · kg, 12 ft · lb)
To Next Page
Loading...
