Hisun HS700UTV-4 - Adjusting the Front and Rear Shock Absorbers(Option 2)

MAINTENANCE AND ADJUSTMENT OF THE UTV
- 116-
preference, weight, and the operating
conditions.
1. Adjust:
• spring preload Turn the adjuster to increase①
or decrease the spring preload.
Standard position: 2
Minimum (Soft) position: 1
Maximum (Hard) position: 5
ADJUSTING THE FRONT AND REAR SHOCK
ABSORBERS (Option 2)
WARNING :
These shock absorber assemblies contain
highly pressurized nitrogen gas, read an
d
understand the following information befor
e
handling the shock absorber assemblies.
· Do not tamper with or attempt to open th
e
cylinder assemblies.
· Do not subject the shock absorbe
r
assemblies to an open flame or other high
heat source. This may cause the unit to
explode due to excessive gas pressure.
· Do not deform or damage the cylinders in
any way. Cylinder damage will result in poo
r
damping performance.
· Do not dispose of a damaged or worn ou
t
shock absorber assembly yourself. Take th
e
shock absorber assembly to a HSUN deale
r
for any service.
The spring preload, rebound damping and
compression damping forces of the front and
rear shock absorber assemblies can be adjusted
to suit the operating conditions.
NOTE:
Never turn an adjusting mechanism beyond
the
minimum and maximum settings.