MAINTENANCE AND ADJUSTMENT OF THE UTV
- 106-
NOTE:
Brake fluid may erode painted surfaces o
plastic parts. Always clean up spilled fluid
immediately.
WARNING
:
·
Use only the designed quality brake fluid:
otherwise, the rubber seals ma
deteriorate, causing leakage and poo
brake performance.
·
Refill with the same type of brake fluid:
mixing fluids may result in a harmfu
chemical reaction and lead to poo
performance.
·
Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in a vapor lock.
4. Close the hood.
CHECKING THE FRONT BRAKE PADS
1. Remove:
·front wheels
2. Check:
·brake pads
Wear indicator groove ○
a
almost disappeared
Replace the brake pads as a set.
Refer to “FRONT AND REAR BRAKES” in
chapter 5.
Brake pad wear limit ○a
1.5 mm (0.06 in)
3. Operate the brake pedal.
4. Install:
·front wheels
CHECKING THE REAR BRAKE PADS
1. Check:
·brake pads
Wear indicator groove ○
a
almost disappeared
To Next Page
Loading...
