CHASSIS
- 288-
the refrigerating fluid until the water level stop
to change, then screw the exhaust nut, cove
the water tank lid. The water tank inspection is
finished. .
2. Check:
• cooling system
Leaks
Repair or replace any faulty part.
Recommended antifreeze:
High quality ethylene glycol antifreeze
containing corrosion inhibitors for
aluminum engines.
Antifreeze and water mixing ratio: 1:1
Total amount: 1.8L
(1.58 lmp qt,1.90 US qt)
Coolant reservoir capacity
(up to the maximum level mark):
0.3L(0.26lmp qt,0.32 US qt)
OIL COOLER
CHECKING THE OIL COOLER
1. Check:
• oil cooler
if the oil cooler is distortion and leak oil.To
adjust the distortion one, and welding the leak
one.If it can not solve, instead the oil cooler.
2. Check:
• all metal hose
• all rubber hose
Cracks/damage
Replace.
3.To take a pressure resistance inspection to the
Oil Cooling System after maintain, the
pressure is 0.3MPA.
4. After take the pressure resistance inspection,
pass over 0.03MPA compressed air through
the connecting oil cooler, steel oil pipe and
Rubber Pipe for 3 minutes, do not leak.
5. When it is finished assembly, pour the" L"
engine oil, then start the engine for 10 minutes
to check whether leaks. If it is not ,the Oil
Cooling System maintain is finish.
To Next Page
Loading...
