CHASSIS
- 287-
CHECKING THE RADIATOR
1. Check:
• radiator fins
Obstruction
Clean.
Apply compressed air to the rear of the
radiator
Damage Repair or replace.
1NOTE:
Straighten any flattened fins with a thin,
flat-head screwdriver.
2. Check:
• all rubber hose
Cracks/damage
Replace.
3. Check:
• Bolt clip
The tightness of Bolt clip. If loosen, please
have the hoop tightened immediately.
4. Check:
• radiator fan
Damage
Replace.
Malfunction
Check and repair.
5. Measure:
• radiator cap opening pressure
Below the specified pressure
Replace
the radiator cap.
Radiator cap opening pressure
107.9 ~ 137.3 KPa
(1.079 ~ 1.373 kg/cm
2
, 15.35 ~ 19.53 psi)
a. Install the radiator cap tester ①and adapter
② onto the radiator cap ③.
b. Apply the specified pressure for ten sec-onds
and make sure that there is no drop
inpressure.
4. Check:
INSTALLING THE RADIATOR
1. Fill:
• cooling system
Start engine when pour full the refrigerating
fluid, loose the exhaust nut on the pipe, the
water level will get lower at this time, Supply
To Next Page
Loading...
