MAINTENANCE AND ADJUSTMENT OF THE UTV
- 109-
WARNING
:
Check the operation of the brake afte
bleeding the brake system.
ADJUSTING THE SELECT LEVER SHIFT ROD
① Neutral
② High
③ Low
④ Reverse
⑤ Select lever shift rod
⑥ Shift control cable
WARNING
:
Before shifting, you must stop the vehicle
and take your foot off the accelerator pedal.
Otherwise, the transmission may be
damaged
1. Adjust:
·Select lever shift rod
a. Make sure the select lever is in NEUTRAL.
b. Loosen both locknuts .①
WARNING
:
The select lever shift rod locknut (select leve
side) has left-handed threads. To loosen the
locknut, turn it clockwise.
c. Tighten the locknuts . ①
ADJUSTING THE BRAKE LIGHT SWITCH
NOTE:
· The brake light switch is operated b
movement of the brake pedal.
·The brake light switch is properly adjusted
when the brake light comes on just before
the braking effect starts.
1 Check
·brake light operation timing
Incorrect
Adjust.
2. Adjust:
To Next Page
Loading...
