MAINTENANCE AND ADJUSTMENT OF THE UTV
- 124-
any time during the charging process,
disconnect the battery charger and let the
battery cool before reconnecting it. Hot
batteries can explode!
• As shown in the following illustration, the
open-circuit voltage of an MF battery
stabilizes about 30 minutes after charging
has been completed. Therefore, wait 30
minutes after charging is completed before
measuring the open-circuit voltage.
Charging method using a variable-current
(voltage) charger
NOTE:
• Leave the battery unused for more than 30
minutes before measuring its open-circuit
voltage.
• Set the charging voltage to 16 ~17 V. (If the
charging voltage is lower, charging will be
insufficient, if it is higher, the battery will be
over-charged.)
To Next Page
Loading...
