Hisun HS700UTV-4 - Page 196

ENGINE
- 183 -
1、CHECK
1). Checking the oil pump
• rotor housing
• rotor cover
Cracks/wear/damage
Replace.
• oil pump operation
Unsmooth
Repeat steps #1 and #2 or
replace the defective parts.
2). Checking the oil strainer
• oil strainer ①
• O-ring ②
Damage
Replace.
Contaminants
Clean with engine oil.
2、MEASURE
1). Measure the oil pump
• tip clearance(a)
(between the
inner rotor ① and the out rotor ②)
• side clearance(b)
(between the outer rotor ② and the pump
housing ③)
• body clearance (c)
(between the outer rotor ② and the pump
housing ③)
Out of specification
Replace the oil pump.
Tip clearance Limit: 0.23 mm
Side clearance Limit: 0.17 mm
Body clearance Limit: 0.24 mm
2). Measure the crankshaft
• crank width (A)
Out of specification
Replace the crankshaft.
Crank width
74.95 ~ 75.00 mm
• side clearance (D)
Out of
specification Replace the crankshaft
.