Hisun HS700UTV-4 - Page 264

CHASSIS
- 251-
CHECKING THE JOINTS
1.Check
• Dust boots
Cracks/damage
Replace
2.Check
• double off-set joint spline
• ball joint spline
• shaft spline
Wear/damage
Replace.
• balls and ball races
• inner surface of double off-set joint
Pitting/wear/damage
Replace.
• Check whether the inner and outer ball cage
of the left and right transmission shaf
t
movement is Smooth, ceaseless. If it is
stagnation and obvious becoming less loosen,
replace it.
• Disassembly the left and right transmission
shaft ,cleaning and assemble it again.
1NOTE:
1. The dustproof rubber wrap on the ball cage
is not allow to contact with the gas and
diesel oil.
2. The dustproof rubber wrap does not allow
to be scratched, a slight scratches can
damage the dustproof rubber wrap very
quickly.
3. When reassembles the left and right
transmission shaft, in the ball cage must
sufficiently enter 2/3 volume with the
Lithium lubricating.
CHECKING THE DIFFERENTIAL GEAR
1.Check:
• gear teeth
Pitting/galling/wear
Replace drive pinion
gear and ring gear as a set.
• bearings
Pitting/damage
Replace.