9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
112
V.Tail (ACRO and GLID)
It is not necessary to access or change this menu to y a V tail aircraft.
The default values are 100% movement in all directions.
{{
Tip
To change the end points on the V-tail servos while they are performing the rudder and elevator functions:
a. Select V. Tail from the model menu.
b. The rst screen allows adjustment of the
elevator function. Select the control and
direction you wish to change.
c. Press the +RST- icon to change the rate values
for the elevator servo as it performs the elevator
and rudder control functions. Repeat the
process for all values on this menu page you
want to change.
d. Press the 1/2 icon to access the next page
containing the same adjustment format on the
rudder control surfaces.
e. Change the rate values for the rudder servo
as it performs both the rudder and elevator
control functions. Repeat for all values on this
page you want to change.
f. Press the Exit icon to back out to the
model menu.
V.Tail Set up
Aircraft with a V tail can use this function to limit the travel of the tail control servos up, down or both directions.
### This function can be inuenced by the ight condition feature ###
To Next Page
Loading...
