HITEC Aurora 9X - Flight Conditions, Idle-Ups and Throttle Hold

9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
FLT.COND (HELI)
You are not obligated to use the ight condition / idle-up feature to y a heli.
Note
Flight Conditions, Idle-Ups and Throttle Hold.
When a heli aircraft is selected as the active model, the ight condition function becomes the heli idle-up and throttle
hold feature.
There are 8 ight conditions:
t/PSNBM
t*EMFVQ
t5ISPUUMFIPME
t5XPPQFODPOEJUJPOTDPOEJUJPOBOE
The following Aurora 9X features support ight mode programming in heli mode
Dual Rate & Exponential
Servo Speed
Programmable Mixes
Throttle Curve
Pitch Curve
Fuel Mixture
Needle Control
Gyro Sensitivity
Swash -> Throttle Mix
Rudder -> Throttle Mix
Governor
Aurora 9X sets 1/2 Idle up Hold by default.
Once you are familiar with settings for the Aurora 9X, choose your preferred switch options.
This is an additional condition for Normal condition when idle up is 1/2.
It is set to hold when switch E is located at the bottom in normal condition and idle up 1 is pulling up to the top and idle up 2 and switch
G are pulling in middle step.
a. Press FLT.COND in the model menu.
b. Idle-up 1 has been set by default as follows.
128