HITEC Aurora 9X - Model Menu-Common Model Functions to ACRO and GLID; Flt.cond (Acro); Flight Conditions; Spoiler

9 CHANNEL 2.4GHz AIRCRAFT COMPUTER RADIO SYSTEM
94
FLT.COND (ACRO)
FLT.COND Flight Conditions
Spoiler Spoiler control
SPO- ELE Spoiler to Elevator mix
AIL-RUD Aileron to Rudder mix
ELE-CAM Elevator to Camber mix
RUD-AIL Rudder to Aileron mix
AIL DIFF Aileron Dierential feature
AIL- FLP Aileron to Flap mix
CAMBMIX Wing trailing edge mix
FLP CON Flap control mix
V.Tail V-Tail mix feature
AILEVATR Split elevator and aileron inclusion mix
Elevon Elevon or ying wing mix
Thro.Cut Throttle cut position
T.Cu rve Throttle curve
IdleDown Throttle Idle down position
B-y Buttery or “Crow” mix
FlapTrim Flap Trim Mix ACRO only
Knifemix Knife Edge Mix ACRO only
SnapRoll Snap roll function ACRO only
Oset Oset function GLID only
Motor Glider motor control feature GLID only
Launch Launch mix GLID only
The following features are common to the ACRO and GLID model programs. Depending on the active models features
as you dened them during the model set-up process, these functions may, or may not be in the model menu.
You are not obligated to use the ight condition feature to y an aircraft.
Note
Flight Conditions
The Flight Condition feature is clearly the most sophisticated and exible of all the Aurora 9X functions.
There are 7 ight conditions, condition 2 through 8. This is in addition to the NORMAL condition for a total of 8 dierent
ight conditions you can program for the active model’s memory.
As you read the manual, note this graphic appears at the end of the description text on the following functions:
### This function can be inuenced by the ight condition feature ###
The following Aurora 9X features support ight condition programming in ACRO and GLID.
1. Dual Rate & Exponential
2. Servo Speed
3. Programmable Mixes
4. Throttle Curve
5. Fuel Mixture
6. Spoiler to Elevator Mix
7. Aileron to Rudder Mix
8. Elevator to Camber Mix
9. Rudder to Aileron Mix
10. Aileron Dierential
11. Aileron to Flap Mix
12. Camber Mix
13. Launch
14. Flap Control
15. Gyro Sensitivity
16. Snap-Roll
17. V-tail Mix
18. Elevon Mix
19. Ailevator Mix
20. Knife Edge Mix
Model Menu-Common Model Functions to ACRO and GLID
Section Six