HP 8360 L Series - Page 245

POWER (MENU_)
Programming Codes
SCPI: NONE
Analyzer: NONE
See Also
Softkeys listed previously under this menu key, IALC),
(FLTNESS ON/OFF), [POWER LEVEL), and (-ON/OFF_).
“Introducing the HP 8360 L-Series Swept CW Generators” in
Chapter 1 and “Getting Started Advanced” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Power Offset
Function Group
POWER
Menu Map 5
Description
This softkey changes the mapping of absolute power parameters
on input to the swept CW generator. It does not change the RF
output produced by the swept CW generator. The equation used to
determine the displayed value is:
Entered or Displayed Power = Hardware Power (ALC) + Active Offset
Programming Codes
SCPI:
POWer:OFFset:STATe ON]OFF]l]O
POWer:OFFset <num>[DB]]MAXimum]MINimum]UPJDOWN
Analyzer: NONE
See Also CPOWER LEVEL) and POWER [MENU-.
P-6 Operating and Programming Reference