Printer
Adrs
Preset Mode User
Function Group
SYSTEM
Menu Map
8
Description
This softkey sets the standard starting configuration of the
swept CW generator when the (PRESET) key is pressed, as set
by the user. You can define any starting conditions: Set up the
swept CW generator with the conditions you want, then select
Preset Mode User. Now whenever you press
(PRESET),
the swept
CW generator returns to the configuration you set. If preset mode
user is set, when you press
[PRESET),
the swept CW generator displays
the following:
***
USER DEFINED PRESET RECALLED ***
You can still do a factory preset. When the user preset mode
is active, the softkey Factory Preset appears when you press
[PRESET).
An asterisk next to the key label indicates that this feature
is active.
Programming Codes
SCPI:SYSTem:PRESet TYPE USER
Analyzer: NONE
See Also
(PRESET),
Preset Mode Factory, Save User Preset
“Changing the Preset Parameters” in Chapter 1
Printer Adrs
Function Group
Menu Map
Description
Programming Codes
See Also
SYSTEM
8
This softkey lets the swept CW generator recognize a printer
address between 0 and 30. The swept CW generator can act as a
controller for a printer during self-test, if the log-to-a-printer feature
is initiated.
SCPI: DIAGnostic:INSTrument:PRINTer:ADDRess <num>
Analyzer: NONE
Adrs Menu,
Selftest
(Full)
Operating and Programming Reference
P-l 1
To Next Page
Loading...
Need help?
General
