HP 8360 L Series User Manual

l *OPT?
This returns a string identifying any device options.
0 *RCL <r-mm>
The instrument state is recalled from the specified memory register.
The value range is from 0 to 8.
a *RST
The swept CW generator is set to a predefined condition as follows:
CALibration:PEAKing:AUTO OFF
CALibration:POWer:ATTenationO DBM
CALibration:POWer:RANGe 1
CALibration:SPAN:AUTO OFF
CORRection:FLATness? returns a0
CORRection:ARRay clear
CORRection:FLATness:POINts? returns a 0
CORRection:STATe OFF
DIAGnostics:ABUS:AVERage 1
DIAGnostics:TEST:ENABleALL
DIAGnostics:TEST:LOG:SOURceFAIL
DIAGnostics:TEST:LOG[:STATe] OFF
DIAGnostics:TEST:LOOP OFF
DISPlay[:STATe] ON
FREQuency:CENTer value is (MAX+MIN)/2
FREQuency:CW value is (MAX+MIN)/2
FREQuency:CW:AUTO OFF
FREQuency:MANualvalueis (MAX+MIN)/2
FREQuency:MODE CW
FREQuency:MULTiplier 1
FREQuency:MULTiplier:STATe OFF
FREQuency:OFFSetO
FREQuency:OFFSet:STATe OFF
FREQuency:STARtMINimum
FREQuency:STEP calculated from span
FREQuency:STEP:AUTO ON
FREQuency:STOPMAXimum
1NITiate:CONTinuous OFF
LIST:DWELlvalueis 100 ps (MINimum)
LIST:DWELl:POINts? returns al
LIST:FREQuency valueis (MAX+MIN)/2
LIST:FREQuency:POINts? returns al
LIST:MANuall
LIST:MODEAUTO
LIST[:POWer]:CORRection 0
LIST[:POWerl:CORRection:POINts? returns al
LIST:TRIGger:SOURce IMMediate
MARKer[n]:AMPLitude[:STATel OFF
MARKer[n]:AMPLitude:VALue 2 DBM
MARKer[n]:FREQuency value same as FREQ:CENT *RST value
Operating and Programming Reference S-13

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English