a
*STB?
Queries the Status Byte. This is a non-destructive read.
l
*TRG
This command performs the same function as the Group Execute
Trigger command defined by IEEE 488.1.
l *TST?
A full
selftest
is performed, without data logging or looping, and
returns one of the following error codes:
Error Code
Definition
0
Test passed.
1
Test failed.
2
Test not run yet. (This is an unlikely event
.)
3
Test aborted.
4
Can not execute the test.
5
Can not execute the test, test skipped.
-1 Unrecognized result, software defect.
a
*WA1
This causes the swept CW generator to wait for the pending
commands to be completed before executing any other commands.
For example, sending the command:
TSW;*WAI
allows for synchronous sweep operation. It causes the swept CW
generator to start a sweep and wait until the sweep is completed
before executing the next command.
Operating and Programming Reference S-15
To Next Page
Loading...
Need help?
General
