HP 8360 L Series User Manual

TrigOut Delay
Tracking Menu
Function Group
Menu Map
Description
Programming Codes
See Also
POWER, USER CAL
5, 9
In the menu structure there are two occurrences of this softkey. One
occurs in the POWER (MENU), the other occurs in the USER CAL
(MENU). Both softkeys operate the same way. These softkeys access
the tracking menu.
Auto Track
Realigns the swept CW generator’s output
filter and oscillator to maximize output power
for the swept frequency mode.
Peak RF Always
Periodically realigns the swept CW
generator’s output filter and oscillator to
maximize output power for the CW frequency
mode.
Peak RF Once
Realigns the swept CW generator’s output
filter and oscillator to maximize output power
for the CW frequency mode.
SCPI: NONE
Analyzer: NONE
Softkeys listed above.
“Using the Tracking Feature” in Chapter 1
TrigOut Delay
Function Group
Menu Map
Description
SWEEP
7
This softkey lets you specify the amount of time after phase-lock
before a trigger pulse is sent out of the TRIGGER OUTPUT BNC.
The delay can be set from 0 to 3.2 seconds. An asterisk next to the
key label indicates this feature is active.
Operating and Programming Reference T-3

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English