HP 8360 L Series - Page 409

command statements, fundamentals, l-57
command tables
how to read, 1-71
how to use, l-71
command trees
defined, l-68
how to change paths, l-68
how to read, l-68
simplified example, 1-71
using efficiently, l-69
commas
problems with commas in input data, l-65
proper use of, l-69, l-82
common commands, l-67, l-69
defined, l-67
compare, analyzer language to SCPI, 3-24
compensation
negative diode detectors, l-47
condition register, l-106
connections
to HP 83550 series mm-wave modules, 3-22
to HP 8510 network analyzer, 3-21
to HP 8757C/E
scalar analyzer, 3-21
to HP 8970B noise figure meter, 3-22
connector
10 MHz reference input, C-5
10 MHz reference output, C-5
auxiliary interface, C-5
auxiliary output, C-4
external ALC, C-4
HP-IB, C-6
RF output, C-10
source module interface, C-8
stop sweep in/out, C-4
sweep output, C-4
trigger input, C-5
trigger output, C-5
volts/GHz, C-5
Z-axis blank/markers, C-5
connectors, C-4-10
connectors, mating, 3-8
CONT, 1-12, C-10
continuous leveling, L-l
continuous sweep, 1-12, C-10
continuous wave frequency, C-12
control attenuator separately, U-l
controller
defined, l-63
controller, definition of, l-56
control power level, P-2
conventions, typeface, vii
cooling airflow, 3-9
copy frequency list, C-10
copy list, C-10
correcting for power sensitive devices, F-4
Index-4