stepped functions, S-60
sweep mode ramp, S-65
sweep modes, l-12
sweep mode step, S-66
sweep mode stepped frequency list, S-65
sweep once, S-51
sweep output connector, C-4
sweep span calibrate always, S-66
sweep span calibrate once, S-67
sweep span calibration, F-10
sweep time, l-10
sweep time coupled to stepped sweep, D-8
sweep time key, S-67
sweep time set automatically, S-68
swept CW generator as controller, 3-7
swept CW generator, no front-panel change address, 3-8
swept CW generator remote address, A-l, E-l
swept CW generator reset command, S-13
swept CW generator status, D-5
swept offset measurement, S-58
swept operation
center frequency, C-l
swept power, 1-18
switch, line, L-5
synchronization command, S-12
synchronization, example program, l-99
synchronous sweep, example program, l-101
synchronous sweep operation, interface bus, S-15
syntax diagrams
commands, 1-81
message terminators, l-80
program message, l-80
response message, l-82
syntax drawings, l-57
system controller on bus message, 2a-4
system interface connector, C-6
system language (SCPI), P-14
system menu keys, S-69
T
tab
proper use of, l-69
talker, definition of, l-56
temperature, operating, 3-9
terminators
program message, l-64, 1-81
program message:use in examples, l-64
response message, l-65
time, sweep set automatically, S-68
tmr conflct fail, F-4
track fail, F-2
tracking, 1-49
tracking functions, T-2
transition filter, l-107
in general status register model, l-106
Index-22
To Next Page
Loading...
