HP 8360 L Series User Manual

generator is using (address 13 is assumed). Refer to the menu
map 8, System, for the key sequence necessary to reach softkey
Meter Adrs .
Enable User Flatness Correction
13. When the operation is complete, (a message is displayed) the
flatness correction array is ready to be applied to your setup.
14. To save the swept CW generator parameters including the
correction table in an internal register, press (SAVE) 0
(n = number 1 through 8).
15. Disconnect the power meter/sensor and press (FLTNESS ON/OFF)
(amber LED on). Th e p ower produced at the point where the
power meter/sensor was disconnected is now calibrated at the
frequencies and power level specified above.
1-42 Getting Started Advanced

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English