HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 503
largest-free-
partition-
space-numeric
string Unformatted largest-free-partition-space value in 512-byte blocks.
num-drives-per-
low-level-array
uint8 • For a RAID-10 or RAID-50 vdisk, the number of disks in each sub-vdisk.
• For other RAID levels, 1.
num-expansion-
partitions
uint8 Not used.
num-partition-
segments
uint8 Number of free segments available for expansion of volumes.
new-partition-
lba
string Maximum number of 512-byte blocks that could be allocated to a newly created
volume. The value is formatted to use the current base, precision, and units.
Expanding a volume in the same vdisk will reduce this amount.
new-partition-
lba-numeric
string Unformatted new-partition-lba value in 512-byte blocks.
array-drive-
type
string Type of disk used in the vdisk.
• SAS: Dual-port SAS.
• SAS-S: Single-port SAS.
• SATA: Dual-port SATA.
• SATA-S: Single-port SATA.
array-drive-
type-numeric
string Numeric equivalents for array-drive-type values.
• 3: SATA
• 4: SAS
• 5: SATA-S
• 6: SAS-S
is-job-auto-
abortable
string • false: The current job must be manually aborted before you can delete the
vdisk.
• true: The current job will automatically abort if you delete the vdisk.
is-job-auto-
abortable-
numeric
string • 0: false
• 1: true
serial-number string Vdisk serial number.
blocks uint64 Unformatted size value in 512-byte blocks.
disk-dsd-
enable-vdisk
string • Disabled: DSD is disabled for the vdisk. This is the default.
• Enabled - all spinning: DSD is enabled for the vdisk.
•
Partial spin-down: DSD is enabled for the vdisk and its disks are
partially spun down to conserve power.
• Full spin-down: DSD is enabled for the vdisk and its disks are fully spun
down to conserve power.
disk-dsd-
enable-vdisk-
numeric
string • 0: Disabled
• 1: Enabled - all spinning
• 2: Partial spin-down
• 3: Full spin-down
disk-dsd-delay-
vdisk
uint32 The period of inactivity after which the vdisk's disks and dedicated spares
automatically spin down, from 1–360 minutes. DSD is enabled by a value in this
range, or is disabled by the value 0.
total-data-
transferred
bytes Total amount of data read and written since the last sampling time.
Table 90 virtual-disks properties (continued)
Name Type Description

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures