HP ProLiant ML310 Setup And Installation Guide

Contents
Figure 3-25: Removing a DIMM........................................................................................ 3-28
Figure 3-26: Locating DIMM sockets ................................................................................ 3-29
Figure 3-27: Installing a DIMM .........................................................................................3-30
Figure 3-28: Locating the processor socket........................................................................ 3-31
Figure 3-29: Removing the processor from the system board............................................ 3-32
Figure 3-30: Installing a processor......................................................................................3-33
Figure 3-31: Installing the heatsink .................................................................................... 3-34
Figure 3-32: Securing the heatsink retainer clips................................................................ 3-34
Figure 3-33: Plugging in the system fan............................................................................. 3-35
Figure 3-34: Removing the battery from the SCSI system board....................................... 3-38
Figure 3-35: Removing the battery from the ATA system board....................................... 3-38
Figure 4-1: SCSI cable with terminator................................................................................ 4-3
Figure 4-2: Internal SCSI components.................................................................................. 4-4
Figure 4-3: 68-to-50 pin (wide-to-narrow) SCSI adapter..................................................... 4-5
Figure 4-4: Cabling a SCSI hard drive or other device......................................................... 4-6
Figure 4-5: Removing the SCSI cable from the system board.............................................. 4-7
Figure 4-6: Connecting the SCSI cable to the Smart Array Controller ................................ 4-8
Figure 4-7: Cabling a two-bay hot-plug SCSI drive cage..................................................... 4-9
Figure 4-8: ATA cable connectors...................................................................................... 4-11
Figure 4-9: Internal ATA components................................................................................ 4-12
Figure 4-10: ATA cabling sequence................................................................................... 4-13
Figure 4-11: Cabling an ATAPI tape drive......................................................................... 4-15
Figure E-1: Power button and server LEDs..........................................................................E-3
Figure E-2: System Board LEDs ..........................................................................................E-4
Figure E-3: Network controller LEDs ..................................................................................E-7
Figure E-4: System configuration switch default settings ....................................................E-8
Figure E-5: System ID Switch............................................................................................E-12
List of Tables
Table 1-1: Drive Bay Dimensions ........................................................................................ 1-4
Table 1-2: Front Panel Components ..................................................................................... 1-5
Table 1-3: Rear Panel Connectors ........................................................................................ 1-6
Table 1-4: NIC Connector LEDs.......................................................................................... 1-7
Table 1-5: SCSI System Board Components........................................................................ 1-9
Table 1-6: ATA System Board Components...................................................................... 1-11
Table 3-1: Expansion Slots................................................................................................. 3-24
Table 3-2: DIMM Sockets.................................................................................................. 3-29
HP ProLiant ML310 Server Setup and Installation Guide ix
HP CONFIDENTIAL
Writer: Ted Weiman File Name: a-frnt.doc
Codename: Son of Beast Part Number: 274431-002 Last Saved On: 11/22/02 1:55 PM

HP ProLiant ML310 Specifications

General

Form Factor	Tower
Processor Sockets	1
Maximum Memory	32GB
Memory Slots	4
Storage Controller	HP Dynamic Smart Array B120i
Processor	Intel Xeon E3-1200 series
Memory Type	DDR3
RAID Support	RAID 0, 1, 10
Storage	Up to 4 LFF (3.5-inch) drives
Hard Drive Interface	SATA
Network	1Gb Ethernet
Power Supply	350W
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Expansion Slots	1 x PCIe 2.0 x1