PoE Port Schedule 109
Adding a Periodic Time Period
To configure a periodic schedule, select the schedule from the Schedule list and click Add Periodic.
Figure 77. Add Periodic Time Period Page
Table 57. Add Periodic Time Period Fields
Click Apply to save any changes for the current boot session. The changes take effect immediately but
are not retained across a switch reset unless you click Save Configuration.
NOTE:
Periodic time periods cannot overlap. Consecutive periodic time periods must be at least three min-
utes apart.
Field Description
Schedule The schedule to be configured.
Applicable Days Select the days on which the periodic time range entry is active. If you select Days of Week,
you can select multiple days from the Start Days list.
Start Days Indicates the days on which the time period becomes active. The days are autoselected to
correspond to your choice in the Applicable Days field.
If you selected Days of Week, you can hold down the Ctrl key to select multiple days.
Starting Time of Day Specify the time of day that the entry becomes active by entering the information in the field
or by using the scroll bar in the Choose Time window, which displays when you click the field.
You can click Now to use the current time of day. Click Done to close the window.
End Days Indicates the days on which the time entry ends. The days are autoselected to correspond to
your choice in the Applicable Days. If you selected Days of Week, the selected days
correspond to your selections in the Start Days list.
Ending Time of Day Specify the time of day that the entry becomes inactive by entering the information in the field
or by using the scroll bar in the Choose Time window, which displays when you click the field.
Click Now to use the current time of day. Click Done to close the window.
To Next Page
Loading...
