HPE OfficeConnect 1920S8G series

IPv4 Routing 121
Table 64. Configured Route Summary Fields
Adding a Static Route
1. From the Configured Route Summary page, click Add.
The Add Route page displays:
Figure 84. Add Route Page
2. Next to Route Type, select Default route, Static or Static Reject from the menu.
 Default: Enter the default gateway address in the Next Hop IP Address field.
 Static: Enter values for Network Address, Subnet Mask, Next Hop IP Address, and Prefer-
ence.
 Static Reject: Packets to these destinations will be dropped.
3. Click Apply.
The new route is added, and you are returned to the Configured Routes page.
Your changes take effect immediately but are not retained across a switch reset unless you click Save
Configuration.
Removing a Route
To remove one or more configured routes, select each route to delete and click Remove.
Field Description
Network Address The IP route prefix for the destination.
Subnet Mask Also referred to as the subnet/network mask, this indicates the portion of the IP interface
address that identifies the attached network.
Next Hop IP Address The next hop router address to use when forwarding traffic to the destination.
Next Hop Interface The outgoing interface to use when forwarding traffic to the destination.
Preference The preferences configured for the added routes.
NOTE:
The route type you select determines the fields available on the page.