System Time Pages 27
Click Apply to update the switch configuration. Your changes take effect immediately but are not
retained across a switch reset unless you click Save Configuration.
Time Zone Configuration
The Time Zone Configuration page is used to configure your local time zone.
To display this page, click Setup Network > System Time in the navigation pane and click the Time
Zone tab.
Figure 9. Time Zone Configuration Page
Table 6. Time Zone Configuration Fields
Click Apply to update the switch configuration. Your changes take effect immediately but are not
retained across a switch reset unless you click Save Configuration.
Last Update Status The status of the last update request to the SNTP server, which can be one of the following
values:
Other—None of the following values apply or no message has been received.
Success—The SNTP operation was successful and the system time was updated.
Request Timed Out—A SNTP request timed out without receiving a response from the
SNTP server.
Bad Date Encoded—The time provided by the SNTP server is not valid.
Version Not Supported—The SNTP protocol version supported by the server is not com-
patible with the version supported by the switch client.
Server Unsynchronized—The SNTP server is not synchronized with its peers. This is
indicated via the leap indicator field in the SNTP message.
Blocked—The SNTP server indicated that no further requests were to be sent to this
server. This is indicated by a stratum field equal to 0 in a message received from the
server.
Requests The number of requests made to the SNTP sever since the switch was rebooted.
Failed Requests The number of failed SNTP requests made to this server since last reboot.
Manual Time Configuration
Time Specify the current time in HH:MM:SS format.
Date Click the date field to display a calendar and select the current date.
Field Description
Time Zone Select the time zone for your location. The default is (GMT) Greenwich Mean Time: Dublin,
Edinburgh, Lisbon, London.
Acronym Specify an acronym for the time zone. The acronym can have up to four alphanumeric
characters and can contain dashes, underscores, and periods.
Field Description
To Next Page
Loading...
Need help?
General