Page 194 Reboot Switch
Reboot Switch
Use this feature to perform a software reboot of the switch. If you applied configuration changes, click
the Save Configuration button in the upper right of any page before rebooting. If the switch is config-
ured to use DHCP to acquire its IP address, the address may change upon restart; you will need to
determine the address before logging back in to the management utility.
To display the Reboot Switch page, click Diagnostics > Reboot Switch.
Figure 139. Reboot Switch Page
Click Reboot to reboot the switch.
If the device configuration has changed but has not been saved, the following window appears after
you click Reboot. This window provides the opportunity to save the current configuration before reboot-
ing the switch.
Figure 140. Save Before Reboot
To Next Page
Loading...
Need help?
General