Factory Defaults 195
Factory Defaults
You can use the Reset Configuration page to restore all settings to their factory default values. All con-
figuration changes, including those that were previously saved, are reset in the running system by this
action.If the switch is configured to use DHCP to acquire its IP address, the address may change upon
restart; you will need to determine the address before logging back in to the management utility.
To display the Factory Defaults page, click Diagnostics > Factory Defaults.
Figure 141. Reset Configuration Page
Click Reset to restore the system to the default settings.
CAUTION:
It is recommended that you back up the current configuration file prior to restoring the
factory defaults configuration. See “Dual Image Configuration” on page 200 for instruc-
tions.
To Next Page
Loading...
