HPE OfficeConnect 1920S8G series User Manual

DHCP Relay 125
Table 67. DHCP Relay VLAN/Interface Configuration Fields
Adding a DHCP Server
To configure an interface or VLAN that can relay DHCP packets to a DHCP server:
1. Click Add.
The Add DHCP Relay VLAN/Interface Configuration page appears.
Figure 89. Add DHCP Relay VLAN/Interface Configuration Page
2. Specify the IP address of the DHCP server to which the interface or VLAN should send packets.
3. Click Apply.
Removing a Relay Interface
To remove the DHCP relay capabilities from one or more VLANs or interfaces, select each interface
and click Remove.
Field Description
Interface The routing interface that has the DHCP relay feature configured.
UDP Destination Port The destination UDP port number of UDP packets to be relayed.
Server Address The IPv4 address of the server to which packets are relayed for the specific UDP Destination
Port.
Hit Count The number of times a packet has been forwarded or discarded according to this entry.

HPE OfficeConnect 1920S8G series Specifications

General

Brand	HPE
Model	OfficeConnect 1920S8G series
Category	Switch
Language	English